Monte Carlo simulation results for tasks

General discussion and questions about project risk management and risk analysis software RiskyProject. Includes discussion on how to perform efficient project risk analysis using our software.

Moderator: Intaver Support

Post Reply
Posts: 11
Joined: Tue Jun 06, 2006 1:57 am
Location: USA

Monte Carlo simulation results for tasks

Post by MTC465 » Wed Dec 09, 2015 4:14 pm

Have you thought of any easier method to bring up the task charts? Once we have run the simulations, it would be nice just to select a task and bring up the results. Now it takes a couple of extra clicks, which seems unnecessary.

Intaver Support
Posts: 882
Joined: Wed Nov 09, 2005 9:55 am

Re: Monte Carlo simulation results for tasks

Post by Intaver Support » Wed Dec 09, 2015 4:16 pm

After you have run the Monte Carlo schedule risk assessment, you can quickly open the Task charts in any of the Gantt Chart views by double-clicking on the task bar. The charts are available in the Project View, Results Gantt, Success Rate, and Crucial Task.

In the example below, we can see the Crucial Task view is open, by double-click on the task’s bar in the Gantt Chart portion of the view, you can quickly bring up the simulation results, without either using the right-click menu or the Task Simulation Results buttons found on the Analysis tab.

Intaver Support Team
Intaver Institute Inc.
Home of Project Risk Management and Project Risk Analysis software RiskyProject

Post Reply