Number of columns to be printed

This forum containts questions about RiskyProject project risk analysis and risk management software: features, issues, problem reports. If you have any problems or question, please submit it here.

Moderator: Intaver Support

Post Reply
Bergman
Posts: 12
Joined: Sat Nov 26, 2005 12:00 pm
Location: New York

Number of columns to be printed

Post by Bergman » Thu Jun 16, 2016 3:46 pm

How can I adjust number of columns to be printed or saved in the PDF file?

Intaver Support
Posts: 992
Joined: Wed Nov 09, 2005 9:55 am

Re: Number of columns to be printed

Post by Intaver Support » Thu Jun 16, 2016 4:00 pm

RiskyProject allows to print and save to PDF file almost all views and charts. RiskyProject print chart based on how it is presented in RiskyProject view. You need to adjust width of the columns and insert/high column you want to print. For example, if you want to print risk description and risk name from Risk Register, you need to select these column in Risk Register view.

You can also adjust maximum number of columns to be printed. To do it, please click on File -> Print -> Page Setup. At the bottom of the dialog you can adjust number of columns to be printed for each view. This number does not include ID columns. In view ID columns are always present and will always be printed.

Image
Intaver Support Team
Intaver Institute Inc.
Home of Project Risk Management and Project Risk Analysis software RiskyProject
www.intaver.com

Post Reply