General discussion and questions about project risk management and risk analysis software RiskyProject. Includes discussion on how to perform efficient project risk analysis using our software.
Moderator: Intaver Support
- Posts: 19
- Joined: Sat Jun 05, 2010 5:50 am
Is there a way that I can see how many simulations were performed to reach his convergence… I know my client will be asking about that. How many did it take? Etc.
- Posts: 892
- Joined: Wed Nov 09, 2005 9:55 am
Quick answer is that if you go to the Project Summary. Located directly above the finish time chart, is a small field “Number of Samples” which indicates the number of iterations run during the simulation.
This information is also available in the detail charts on the Statistics tab.
Intaver Support Team
Intaver Institute Inc.
Home of Project Risk Management and Project Risk Analysis software RiskyProject