Page 1 of 1

How to set number of simulations

Posted: Mon Jan 09, 2012 11:37 am
by Interstate

I am required to run a minimum number of iterations for a simulation. Everytime I run one it seems to finish to early. How do I set the number of iterations in the Monte Carlo Simulation?

Thank you for any suggestions

Re: How to set number of simulations

Posted: Thu Jan 12, 2012 4:56 pm
by Intaver Support
1. Go to Schedule tab, Settings and Options group and click Options
2. Click the Calculation tab
3. Set the maximum number of simulations in the Maximum number of simulations fields.

Note: If you have convergence enabled (Stop simulations when converged) the simulations may end before the max number is reached.

This information is available in the online Help topic ... tions.html

I hope that this was of some help.

Intaver Support